Hi all,
We are using SW2020 SP4.0 and SMARTEAM® - Editor V5-6R2020 Service Pack 6.
Ok I made a bunch or Wireway virtual assemblies and added a surface of the doors open so I can see interferences.
All the files were saved/released with the Surface hidden (Not Shown) and in SMARTEAM you view a preview they appear as such.
I then in a checked out assembly and turned the surfaces to “Shown” did my checks and then proceeded to hide them all and checked in my assembly.
Now when I recheck the assembly file out, half the wireway modes have the surface file shown?
So how is my assembly file driving this change and how do I correct it or do I have to revise all these models and re-check-in/release them or is there a better way?
Regards,
Jim